Routing elements
141
System functions and features as of R4.1
syd-0570/1.2 – R4.1 – 08.2016
5. 7. 3. 2 User group 14, 15 and 16
1)
• User group 16 is reserved for Capolinea destination 1 and 2.
• User group 14 is reserved for Capolinea destination 3.
• User group 15 is reserved for the switching variant of Capolinea destination 1 and 2
(see "Capolinea", page 147).
5. 7. 3. 3 User groups 30 - 99
Note:
With user groups 30 - 99 (available only in the Mitel 470) no DECT group calls are possible, i.e.
all cordless phones in these user groups are called individually. For many UG members with
cordless phones this can quickly lead to a DECT system overload, with the result that not all
cordless phones are called. Therefore use the cordless phones user groups 1 - 24 if there are
many members (see "Cordless phones", page 138).
5. 7. 3. 4 Application example for a user group
In the call distribution pattern, general bell has been configured with a delay; along with
the operator phones. This means that if the operator consoles is overloaded, the gen-
eral bell will also start to ring after the configured ringing time (e.g. 3 ringing cycles).
The call can then be taken from any terminal.
Other Subjects Related to the User Group:
Call distribution, user configuration, operator phones, general bell, internal traffic, incoming traf-
fic, user group: logging in and out, numbering plan.
Mitel Advanced Intelligent Network:
In an AIN the user group works across networks, i.e. the elements of a user group and the
members of a member group can be spread across different nodes.
1)For Italy only
To Next Page
Loading...
