Mitel 430 - Features Operated Via QSIG; User-Unrelated Features; User-Related Features

Features
325
System functions and features as of R4.1
syd-0570/1.2 – R4.1 – 08.2016
9. 2. 6 Features operated via QSIG
In private QSIG networks a number of features can be operated on third-party PINXs
via QSIG (applies only to MiVoice Office 400 or IntelliGate systems). In such cases it is
irrelevant whether the QSIG networking is effected via a basic rate access or a primary
rate access and which QSIG variant is selected as the protocol. The executing user
obtains (visual) confirmation as to whether or not the feature was successfully carried
out.
9. 2. 6. 1 User-unrelated features
User-unrelated features are operated via abbreviated dialling numbers defined on the
destination PINX and containing the corresponding function codes. These abbreviated
dialling numbers are entered on one’s own PBX as PISN users in the numbering plan.
Note:
Make sure that these abbreviated dialling numbers are barred in the digit barring on all PINXs
for unauthorized users and that no names are assigned to the abbreviated dialling numbers
(bypassing the digit barring).
The following features are supported:
Tab. 126 User-unrelated QSIG features
9. 2. 6. 2 User-related features
Operation of the user-related features is subject to the definition of the PISN users in
one’s own numbering plan. The features can be divided into two groups:
Features That Set up a Call Connection
The following user-related features are supported by the communication server and
can be activated via the keypad, the function key or the Foxkey/Softkeys:
Feature Activate Deactivate
Operate switch groups *85<switch group.> <Pos.>
Actuate door opener *74 <No. of the door intercom sys-
tem>
Switch control output *74 <Call number
1)
>
1)
call number assigned to this control output in the numbering plan
#74 <Call number
1)
>
Enable/bar a one-off remote access *754 #754
Answer coded ringing on general bell *82
Answer ring call on general bell *83
Dial door intercom 851,852 (default values)
2)
2)
Only with Mitel 415/430 and if the corresponding number of ODAB card(s) is fitted