Mitel 430 - User-related authorizations; Exchange access authorizations

Features
326
System functions and features as of R4.1
syd-0570/1.2 – R4.1 – 08.2016
Tab. 127 QSIG features with call connection
Features That Can Be Activated/Deactivated
All remote-controlled user-related features listed in Tab. 313
are supported by the com-
munication server and can be activated or reset via the keypad or function key. The
only requirement is that the PISN user concerned is not protected against remote con-
trol and that *06 is not barred in the internal digit barring for the user executing the fea-
ture.
Example: Clearing CFU for a PISN user: *06 <PISN user number> #21
System configuration
Due to the proprietary protocol, attempts at operating a user-related feature of an older
or third-party PINX via QSIG can lead to incorrect interpretations. That is why the pro-
tocol extension can be inhibited in the trunk group configuration ( =bg) using the pa-
rameter QSIG extension (initialisation setting = Deactivated).
9. 2. 7 User-related authorizations
A class-of-service authorization in the user configuration is required in order to run
user-related features.
In addition specific features and call destinations can be disabled using the internal
digit barring (see "Digit barring", page 192
).
9. 2. 8 Exchange access authorizations
Exchange access authorization
Exchange-to-exchange connections have to be authorized to enable the features con-
ference, Call Forwarding Unconditional and call transfer between two external users
(exchange-to-exchange connections can be further restricted, see "Exchange-to-Ex-
change Connections", page 224).
Authorization to transfer exchange-to-exchange functions to the exchange
For exchange-to-exchange three-party connections to be transferred to the exchange,
the relevant authorizations have to be enabled in the trunk group configuration.
For exchange-to-exchange Call Forwarding Unconditional to be transferred to the ex-
change, the relevant authorizations have to be enabled in the trunk group and user
configurations.
Feature Activate
Call pick-up *86 <PISN user name>