Mitel 430 - Point-To-Point and Point-To-Multipoint Connections

System interfaces
26
System functions and features as of R4.1
syd-0570/1.2 – R4.1 – 08.2016
2. 1. 1. 3 Point-to-Point and Point-to-Multipoint Connec-
tions
Basic accesses can be configured as point-to-point or as point-to-multipoint ( TEI
Management setting in the configuration of the network interfaces).
Point-to-Multipoint Connection without a communication server
The basic access in point-to-multipoint configuration allows a selective dial-up of the
terminals connected in parallel using MSN, the Multiple Subscriber Number. Here the
network itself provides a kind of direct dialling, so to speak.
NT1: Network Termination
MSN: Multiple Subscriber Number
Fig. 3 Single basic access in point-to-multipoint configuration
Note:
The fax with ISDN connection is implemented as a fax card in a PC.
Default setting:
Digital network interfaces are set on point-to-point configuration.
17
061 061 061
8
061
061
061
)D[