Routing elements
127
System functions and features as of R4.1
syd-0570/1.2 – R4.1 – 08.2016
quent caller will obtain busy, provided no alternative destination CDE if busy has
been defined.
• Routing a call to data service destinations:
Data service destinations can be configured for each call distribution element (see
"Data service", page 255
).
5. 5. 3 Routing Functions for Outgoing Calls
Outgoing calls via the line keys of a key telephone are routed via the route entered in
the CDE configuration under Route (see "Key Telephones", page 149
).
5. 5. 4 Other Functions and Settings of the CDE
Name
CDE name is used to assign a name to each call distribution element. The name is
used for identification purposes.
• With incoming calls it is displayed on the system phone.
• With outgoing calls via KT lines it is provided as CNIP.
The name cannot be used for dialling by name.
Displaying DDI
With incoming calls the direct dialling number can also be displayed instead of the
name of the call distribution ( Force showing the DDI number activated). This is
needed for CTI applications in particular.
Activate/deactivate incoming call logging (ICL)
Incoming call logging can be activated or deactivated for each call distribution element
with the parameter Enter ICL data (see "Call logging for incoming calls (ICL)",
page 278).
Specifying the Company Configuration
With the Company setting it can be determined whether this call distribution element
is used in company A or in company B. The parameter is only visible if the system is
configured as company 2 system (see "Two-company system", page 146).
Announcement service
Each call distribution element can be assigned a welcome announcement or the func-
tion Stop or Music for each switch position (see "Announcement service (announce-
ment prior to answering)", page 443).
To Next Page
Loading...
