Mitel 430 - Page 239

Call routing
239
System functions and features as of R4.1
syd-0570/1.2 – R4.1 – 08.2016
Tab. 65 Routing parameter settings
Parameter Parameter value
Trunk group 1:
• Network interfaces Network interfaces in this trunk group
• Max. incoming calls Number of calls allowed simultaneously
• Maximum simultaneous connections Number of connections allowed simultaneously
• Network type Public
• Protocol DSS1
• DDI plan 1 (number of a direct dialling plan)
• Call Distribution Element 1 (relevant only if no suitable DD number is found)
Direct dialling plan 1:
• Direct dialling number 30 2 (reference number of a call distribution element)
Call distribution element 2:
• Call destinations Switch position 1: 330 (PISN user)
• Max. incoming calls Number of calls allowed simultaneously with several destinations
User configuration PISN-BN 330:
• Route 2 (route reference number)
• External call number Not relevant in this case
Route 2:
• Trunk group 2 (reference number of one or more trunk group(s))
• Digit barring Use or do not use digit barring
• Max outgoing calls Number of calls going out simultaneously via this route
• Numbering plan identifier (NPI) PNP
• Type of number (TON) Unknown
Trunk group 2:
• Network interfaces Network interfaces of this trunk group
• Network type Private
• Protocol QSIG or QSIG / PSS1 ISO