Mitel 430 - Page 424

Features
424
System functions and features as of R4.1
syd-0570/1.2 – R4.1 – 08.2016
Tip:
Configure a key with the unlock function.
Unlocking your own terminal
An authorized user unlocks his own terminal. After unlocking it he can either dial di-
rectly within the next 12 seconds or hang up and dial within 60 seconds with or without
dialling by name. Both the terminal settings and the private phone book are available
during those 60 seconds.
Authorized Users
For a user to be able to operate the "Unlock terminal for each call" feature, he must be
known to the system as an internal user and have his own personal PIN. He defines
the PIN on one of his allocated terminals:
• PIN syntax (all terminals): 2 to 10 digits, digits 0 to 9
• PIN validity
– The PIN is valid for unlocking all terminals that were locked with this phone lock
variant.
– The default PIN "0000" cannot be used to unlock a terminal that was locked with
this phone lock variant.
The PIN is stored on the system in the user configuration, where it can also be altered.
Functions
Tab. 247 Unlocking the terminal for each call: Functions
System configuration
Tab. 248 Unlocking the terminal for each call: System configuration
Functions Function codes System phones
Unlocking a third-party for each
call
#36 <User No.> <PIN> System phones:
• The function can be configured onto a key
Unlocking one's own terminal for
each call
#36 <User No.> <PIN> System phones:
• The function can be configured onto a key
Parameter Remarks
User configuration of the terminal to be locked:
• Phone lock
1)
Activates the lock
• Internal digit barring (used by phone lock) • Definition of internal dialling possibilities in the locked state
• Enable #36: Allows unlocking for each call
• Bar #33: Prevents permanent unlocking.
Important: Without this input the lock can be lifted at any time
by the user.