Mitel 430 - Page 461

Features
461
System functions and features as of R4.1
syd-0570/1.2 – R4.1 – 08.2016
Detailed Description
Tab. 294 Switching switch groups
Tip:
Identify the significance of the switching states on the labels of the terminals.
External switches:
The switch groups can also be activated via control inputs, e.g. via a preconfigured
time-switch clock.
External switches have a higher priority, i.e. they must be open (status 0) so that
switching via function key, function code or WebAdmin can be carried out.
Function in prefix dialling
Tab. 295 Switching switch groups: Function
It is possible to view the switch group status and to switch switch groups via WebAdmin
in the switch group configuration with the Position parameter.
System configuration
Tab. 296 Switch groups: System configuration
Reference to Other Features
"Emergency numbers", page 452
"Door bell", page 463
"Announcement service (announcement prior to answering)", page 443
End point Operating sequence / signalling on the terminal Scope
A • The user obtains an acknowledgement tone when
switching On / Off.
• Terminals connected to the S-bus cannot display the
status of switching groups.
• System phones: The switching status is displayed by
the status of the LED or the corresponding symbol on
the display for the function key configured accord-
ingly.
Possible interfaces:
The switch groups are operated locally on
the system.
Requirement:
Authorization is enabled in the user con-
figuration.
Function Function code
1)
1)
xx = 01...20 (Mitel 415/430) or 01...50 (Mitel 470)
y = 1...3
Switch switching group x in position y *85 xx y
Parameter Parameter
Operate switch group User's permission set
Position Switch group configuration in the call routing
Note: Function code and WebAdmin configuration are equivalent, i.e. the change
last made chronologically is the effective one.