Introduction
This manual contains detailed instructions and notes on the operation and use of this machine. For your safety and
benefit, read this manual carefully before using the machine. Keep this manual in a handy place for quick reference.
Important
Contents of this manual are subject to change without prior notice. In no event will the company be liable for direct,
indirect, special, incidental, or consequential damages as a result of handling or operating the machine.
Notes:
Some illustrations in this manual might be slightly different from the machine.
Certain options might not be available in some countries. For details, please contact your local dealer.
Depending on which country you are in, your machine may include certain options as standard. For details, please
contact your local dealer.
Laser Safety:
CDRH Regulations
This equipment complies with requirements of 21 CFR Subchapter J for class 1 laser products. This equipment
contains two GaAlAs laser diodes, 6.2-milliwatt, 770 - 795 nanometer wavelength for each emitter. This equipment
does not emit hazardous light, since the beam is totally enclosed during all customer modes of operation and
maintenance.
Caution:
Use of controls or adjustments or performance of procedures other than those specified in this manual might result
in hazardous radiation exposure.
Notes:
The model names of the machines do not appear in the following pages. Check the type of your machine before
reading this manual. (For details, see p.24 "Machine Types".)
Type 1: 9040/9040b/MP 4000/MP 4000B/LD040/LD040B/Aficio MP 4000/Aficio MP 4000B
Type 2: 9050/9050b/MP 5000/MP 5000B/LD050/LD050B/Aficio MP 5000/Aficio MP 5000B
Certain types might not be available in some countries. For details, please contact your local dealer.
Two kinds of size notation are employed in this manual. With this machine refer to the inch version.
For good copy quality, the supplier recommends that you use genuine toner from the supplier.
The supplier shall not be responsible for any damage or expense that might result from the use of parts other than
genuine parts from the supplier with your office products.
Power Source
120V, 60Hz, 12A or more
Please be sure to connect the power cord to a power source as above. For details about power source, see
Troubleshooting.
To Next Page
Loading...
Need help?
General