• You cannot use the following copy paper with this function:
• Paper smaller than A5, 5
1
/
2
× 8
1
/
2
• Translucent paper
• Label paper (adhesive labels)
• OHP transparencies
• Paper thicker than 169 g/m
2
, 45.5 lb.
• Paper thinner than 60 g/m
2
, 16 lb.
• Postcards
• When an odd number of originals are placed in the ADF, the back of the last page of copied
paper is blank.
• During copying, the image is shifted to allow for the binding margin.
• By default, a binding margin is made on the back side.
Combine
• In this mode, the machine selects the reproduction ratio automatically. This reproduction ratio
depends on copy paper sizes and the number of originals.
• The reproduction ratios selectable by the machine are 25-400%.
• If the calculated ratio is under the minimum ratio, it is automatically adjusted to within available
range. However, with some ratios, parts of the image might not be copied.
• You cannot use custom size paper.
• If the orientation of originals is different from that of the copy paper, the machine will
automatically rotate the image by 90° to make copies properly.
• If the number of originals placed is less than the number specified for combining, the last page
segment is left blank as shown.
Sort, Rotate Sort
• Paper sizes and orientations that can be used in the Rotate Sort function are A4 , B5 JIS
, 8
1
/
2
× 11 , and 7
1
/
4
× 10
1
/
2
.
• The number of copies that can be placed on the tray is as follows. When the number of copies
exceeds capacity, remove copies from the tray. (paper weight: 80 g/m
2
, 20 lb.)
• Internal tray 1
A4, 8
1
/
2
× 11 or smaller: 500 sheets (250 sheets when the optional bridge unit is installed.)
Supplementary Information
173
To Next Page
Loading...
