7. Press [OK].
The standby display appears.
To check the settings, press [Sender Name].
8. Specify the destination, and then press the [Start] key.
• You can confirm transmission results by using both the E-mail TX Results function, which sends the
results by e-mail, and the Communication Result Report printed by the machine. You can set whether
to use both of these together in User Parameter (switch 10, bit 6) in the Facsimile Features menu. See
“Facsimile Features”, General Settings Guide.
• You can use Communication Result Report, etc. to check usage status by specified users. If user
authentication is set, you can check usage by logged-in users. If User Code is set to sender, you can
count the number of uses by each user.
• To cancel the Sender Name, cancel the transmission. See “Canceling a Transmission”.
• p.142 "Canceling a Transmission"
Sender Settings
133
To Next Page
Loading...
Need help?
General