5. Select the destination of notification, and then press [OK].
If you make a mistake, before pressing [OK], press [Clear] or press the selected Destination key again
to turn the highlight off.
[E-mail TX Results] gets highlighted and the destination of notification selected appears.
6. Press [OK].
The standby display appears.
To check the settings, press [TX Mode].
7. Specify a destination, and then press the [Start] key.
• You can program one of the Quick Operation keys with operations for this function. Using the Quick
Operation key allows you to omit steps 3 and 6. For details about Quick Operation Key, see “Facsimile
Features”, General Settings Guide.
• p.131 "Sender Settings"
2. Other Transmission Features
162
To Next Page
Loading...
Need help?
General