• To use this function, set Label Insertion to [On] when registering fax destinations in the Address Book,
and also set “Label Insertion” to on when sending fax documents.
• When there is an image around the area where the Label is to be printed, that image is deleted.
The receiver's name is printed as follows:
• Receiver's name: printed at the top of the page and preceded by “To:”.
• Standard message: the programmed message is printed within the next two lines.
Set this function as follows:
• Set Label Insertion to [On] when programming fax destinations.
• Set Label Insertion to on when sending fax documents.
• On the Standard Message screen, select the standard message you want to print.
1. Place the original, and then select the scan settings you require.
2. Press [TX Mode].
3. Select [Option Setting].
4. Press [Label Insertion] to highlight it.
To cancel Label Insertion, press [Label Insertion] again.
5. Press [OK] twice.
6. Specify the destination, and then press the [Start] key.
Transmission Options
171
To Next Page
Loading...
