4. Press [Program].
When no programs are registered, proceed to step 5.
5. Select a program number in which “Not Programmed” is shown.
If you make a mistake, press [Cancel] and select a program number again.
When you change a Keystroke Program, press [Yes] after pressing the program number you want to
change. If you make a mistake, press [No] and try again.
6. Enter the program name, and then press [OK].
The standby display appears.
If the program name is already registered, the name is displayed. To change the program name,
press [ ], [ ], [Backspace], or [Delete All], and then try again.
You should register the program name.
To cancel a program, press [Cancel]. The display returns to that of step 5.
• Use the same procedure to register and change programs. In step 5, select the program number you
want to change.
• For details about text entry, see “Entering Text”, About This Machine.
• The method of registering or changing programs for the copy function is different from that of the fax
function.
• For the maximum values of the following items, see “Maximum Values”.
• Number of destinations you can register into a Keystroke Program
Programs
305
To Next Page
Loading...
