Ricoh C231 - Page 148

SERVICE PROGRAM TABLE
4-12
C231/C237/C238 SM
No. Display Function Settings
Factory
Setting
Comments
17 Set Combine
Key
Enables the Combine 2
Original mode. The blank
key at the upper left corner
under the top left cover on
the operation panel is used
as the mode key.
0: No
1: Yes
0
•
Except for the
China version
model.
•
SP14 must
be set at 0.
*20 Buzzer On Turns the beeper on. 0: No
1: Yes
0
*21 Prints/Master
Cost
Adjusts the cost ratio of
masters to prints for
accounting purposes.
(When SP4 is set at 1,
This function cannot be
used.)
0 to 50 0 The set number
(0 to 50) is
automatically
added to the
key counter
each time a
master is used.
22
Home
Position
Adjust
The drum home position
(the master eject position)
changes.
0 to 9 5
Never change
the setting.
23
Plot Position
Adjust
The drum stop position for
the master making changes.
0 to 9 5
Never change
the setting.
*25 Clear 2 In 1 Selects whether to reset the
Combine 2 Original mode
automatically after master
making.
0: No
1: Yes
0
26 Feed Timing
Adjust
Adjusts the registration
motor on timing for better
paper registration.
0 to 7 3
27 ADF Current
Down
Lowers the current to the
ADF motor.
0: No
1: Yes
0 If the ADF
motor vibrates
due to a part
variation
causing noise,
reduce the
motor current
with this mode.
28
Paste
Shadow
Erase
Adjusts the Paste Shadow
Erase level that can be set
with the key on the
operation panel. The
shadows of pasted-up
edges on originals lighten.
0: Standard
1: Light
2: Lighter
0
*29 Pht
Background
Correct
Determines whether the
original background
correction is done in Photo
mode.
0: Correc-
tion is
not done.
1: Correc-
tion is
done.
0