Rohde & Schwarz RTP044 - Page 1571

Remote control commands
R&S
®
RTP
1571User Manual 1337.9952.02 ─ 12
22.17.3.4 I²C search settings
In search setup commands, you have to specify the <SearchName> parameter. It is a
string parameter that contains the search definition name. The commands are similar
to I²C trigger commands.
SEARch:TRIGger:I2C:SCONdition.................................................................................1571
SEARch:TRIGger:I2C:RCONdition.................................................................................1571
SEARch:TRIGger:I2C:STCNdition................................................................................. 1572
SEARch:TRIGger:I2C:NACKnowledge...........................................................................1572
SEARch:TRIGger:I2C:SADDress...................................................................................1572
SEARch:TRIGger:I2C:ADOR........................................................................................ 1573
SEARch:TRIGger:I2C:ADData.......................................................................................1573
SEARch:TRIGger:I2C:ACONdition.................................................................................1573
SEARch:TRIGger:I2C:AMODe...................................................................................... 1574
SEARch:TRIGger:I2C:ADDRess....................................................................................1574
SEARch:TRIGger:I2C:ADDTo........................................................................................1574
SEARch:TRIGger:I2C:ACCess......................................................................................1575
SEARch:TRIGger:I2C:ADDO<m>:ENABle......................................................................1575
SEARch:TRIGger:I2C:ADDO<m>:ADRType................................................................... 1575
SEARch:TRIGger:I2C:ADDO<m>[:VALue]......................................................................1576
SEARch:TRIGger:I2C:ADDO<m>:RWBit........................................................................1576
SEARch:TRIGger:I2C:DPOPerator................................................................................ 1576
SEARch:TRIGger:I2C:DPOSition...................................................................................1577
SEARch:TRIGger:I2C:DPTO.........................................................................................1577
SEARch:TRIGger:I2C:DCONdition.................................................................................1577
SEARch:TRIGger:I2C:DMIN..........................................................................................1578
SEARch:TRIGger:I2C:DMAX........................................................................................ 1578
SEARch:TRIGger:I2C:ADNack......................................................................................1578
SEARch:TRIGger:I2C:DRNack......................................................................................1578
SEARch:TRIGger:I2C:DWNack..................................................................................... 1579
SEARch:TRIGger:I2C:SCONdition <SearchName>,<Start>
SEARch:TRIGger:I2C:SCONdition? <SearchName>
Enables the search for the start of the message.
Parameters:
<Start> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:I2C:RCONdition <SearchName>,<RepeatedStart>
SEARch:TRIGger:I2C:RCONdition? <SearchName>
Enables the search for a start condition without previous stop condition.
Protocols