Rohde & Schwarz RTP044 - Page 2046

Remote control commands
R&S
®
RTP
2046User Manual 1337.9952.02 ─ 12
Parameters:
<Protocol> SS | SSP
*RST: SS
Usage: Asynchronous command
22.17.20.2 Digital signal processing (DSP)
BUS<m>:CTLE:DCGain................................................................................................2046
BUS<m>:CTLE:ENBLe.................................................................................................2046
BUS<m>:CTLE:P1FReq............................................................................................... 2046
BUS<m>:CTLE:P2FReq............................................................................................... 2047
BUS<m>:CTLE:Z1FReq............................................................................................... 2047
BUS<m>:USBThree:BITR.............................................................................................2047
BUS<m>:USBThree:DFE:COEFficient........................................................................... 2047
BUS<m>:USBThree:DFE:ENBLe...................................................................................2048
BUS<m>:USBThree:DFE:ESTCoeff...............................................................................2048
BUS<m>:USBThree:DFE:TCONt...................................................................................2048
BUS<m>:USBThree:PROTocol......................................................................................2048
BUS<m>:CTLE:DCGain <DCGain>
Sets the adjustable DC gain. This value can be chosen according to the channel loss
characteristics. For low-loss channels, you can set a value close to 0 dB.
Suffix:
<m>
.
1..4
Parameters:
<DCGain> Range: -100 to 100
Increment: 0.01
*RST: 0
Default unit: dB
BUS<m>:CTLE:ENBLe <EnableCTLE>
Enables the continuous time linear equalization (CTLE) equalization.
Suffix:
<m>
.
1..4
Parameters:
<EnableCTLE> ON | OFF
*RST: OFF
BUS<m>:CTLE:P1FReq <PoleOneFreq>
Sets the pole 1 frequency for the transfer function of the CTLE algorithm.
Suffix:
<m>
.
1..4
Protocols