15. DHCP Server
ROX™ v2.2 User Guide 143 RuggedBackbone™ RX1500
15.2. Configuring DHCP Server
The DHCP Server menu is available under services at services/dhcpserver.
Figure 15.1. DHCP Server menu
Under services/dhcpserver, you can configure the following:
• enable the DHCP service. See Section 15.2.1, “Enabling the DHCP Service”.
• set the interface. See Section 15.2.2, “DHCP Interfaces”.
• configure subnets and pools. See Section 15.2.3, “DHCP Subnets and Pools”.
• configure shared networks. See Section 15.2.4, “DHCP Shared Networks”.
• configure hosts. See Section 15.2.5, “DHCP Hosts”.
• configure host-groups. See Section 15.2.6, “DHCP Host-groups”.
• configure DHCP options. See Section 15.2.8, “DHCP Options”.
Under services/dhcpserver, you can also view a list of active DHCP leases. See Section 15.2.7, “Viewing
Active DHCP Leases”.
15.2.1. Enabling the DHCP Service
To enable or disable the DHCP service, navigate to services/dhcpserver. On the Dynamic Host Control
Protocol (DHCP) server form, enable or disable the DHCP service.
Figure 15.2. DHCP Server form
enabled
Enables and disables the the DHCP server.
15.2.2. DHCP Interfaces
A DHCP listen interface is the interface on which DHCP listens for lease requests. You can configure
multiple DHCP interfaces.
• To view a list of DHCP listen interfaces, navigate to services/dhcpserver/interface.
To Next Page
Loading...
