RuggedCom RuggedBackbone RX1500 User Manual

34. Dynamic Routing
ROX™ v2.2 User Guide 412 RuggedBackbone™ RX1500
Interface Name
Synopsis: string
Interface name.
Authentication Type
Synopsis: string - one of the following keywords { null, message-digest }
The authentication type on this interface.
Link Cost
Synopsis: unsigned integer
The link cost. If not set, it cost is based on reference bandwidth.
Hello Interval
Synopsis: unsigned integer
Default: 10
The time (in seconds) between sending hello packets.
priority
Synopsis: unsigned byte integer
Default: 1
Priority of interface.
Passive Interface
Whether an interface is active or passive. Passive interfaces do not send LSAs to other routers and
are not part of an OSPF area.
Retransmit Interval
Synopsis: unsigned integer
Default: 5
Time (in seconds) between retransmitting lost link state advertisements.
Transmit Delay
Synopsis: unsigned integer
Default: 1
The link state transmit delay (in seconds).
Figure 34.14. Dead Interval Form
A dead interval is the time before considering a router dead.
Dead Interval
Synopsis: unsigned integer
Default: 40
The time before considering a router dead (in seconds).
Number of Hellos Per Second
Synopsis: unsigned byte integer

RuggedCom RuggedBackbone RX1500 Specifications

General

Power Supply	Dual redundant, hot-swappable power supplies
Switching Capacity	Up to 128 Gbps
Operating Temperature Range	-40°C to +85°C
Mounting	DIN rail or panel mount
Certifications	IEEE 1613, IEC 61850-3, EN 50155, EN 50121-4
Power Input	24/48VDC or 110/220 VAC
Enclosure	Rugged metal
Type	Modular Layer 3 switch