15. DHCP Server
ROX™ v2.2 User Guide 144 RuggedBackbone™ RX1500
Figure 15.3. Listen Interfaces table
• To add a DHCP listen interface, enter edit mode, navigate to services/dhcpserver/interface, and click
<Add interface>. On the Key settings form, select an interface from the list and click Add.
15.2.3. DHCP Subnets and Pools
• To view a list of DHCP subnets, navigate to /services/dhcpserver/subnet.
Figure 15.4. Subnet Configuration table
• To add a subnet, enter edit mode, navigate to /services/dhcpserver/subnet, and click <Add subnet>.
On the Key settings form, type a name for the subnet and click Add.
On the Subnet Configuration form, set the subnet parameters.
Figure 15.5. Subnet Configuration form
network-ip
Synopsis: IPv4 address and prefix in CIDR notation
The network IP address for this subnet
shared-network
Synopsis: A string
The shared-network that this subnet belongs to
You can configure DHCP options at the subnet level. Options set at this level override options set at
higher levels.
• To set Lease Configuration and Client Configuration options, navigate to /services/dhcpserver/
subnet{subnet id}/options. For more information, see Section 15.2.8.1, “Lease Configuration Options”
and Section 15.2.8.2, “Client Configuration Options at the DHCP Levels”.
• To set Client Configuration, NIS Configuration, and NetBios Configuration options, navigate to /
services/dhcpserver/subnet{subnet id}/options/client. For more information, see Section 15.2.8.3,
“Client Configuration Options at the DHCP Client Level”.
• To set custom DHCP options, navigate to /services/dhcpserver/subnet{subnet id}/options/client/
custom and click <Add custom>. For more information, see Section 15.2.9, “Custom DHCP Options”.
To Next Page
Loading...
Need help?
General
