RuggedCom RuggedBackbone RX1500

23. WAN
ROX™ v2.2 User Guide 264 RuggedBackbone™ RX1500
• /interface/wan{wan slot and port}/dds/connection/framerelay/dlci configures the Data Link Connection
Identifier (DLCI) parameters.
To set the DDS frame relay parameters:
• Enter edit mode and navigate to /interface/wan{wan slot and port}/dds/connection/framerelay.
Figure 23.40. Frame Relay Parameters form
station
Synopsis: string - one of the following keywords { switch, cpe }
Default: cpe
The behavior of the frame relay connection, i.e. CPE (Customer Premises Equipment) or as a
switch.
signal
Synopsis: string - one of the following keywords { none, q933, lmi, ansi }
Default: ansi
The frame relay link management protocol used.
t391
Synopsis: integer
Default: 10
(Link Integrity Verification polling) Indicates the number of seconds between transmission of in-
channel signaling messages. Valid for cpe.
t392
Synopsis: integer
Default: 16
(Verification of polling cycle) Indicates the expected number of seconds between reception of in-
channel signaling messages transmitted by cpe. Valid for Switch.
n391
Synopsis: integer
Default: 6
Defines the frequency of transmission of full status enquiry messages. Valid for CPE.
n392
Synopsis: integer
Default: 4