Siemens CU230P-2 DP - p0852[0...n] BI: Operation enable; Operation enable; p0854[0...n] BI: Master ctrl by PLC; Master ctrl by PLC

Parameters
List of Parameters
1-112
© Siemens AG 2009 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 11/2009
Description: Sets the signal source for control word 1 bit 3 (enable operation)
Caution: When "master control from PC" is activated, this binector input is ineffective.
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
Note: Bit 3 = 0: Inhibit operation (cancel pulses)
Bit 3 = 1: Enable operation (pulses can be enabled)
Description: Sets the signal source for control word 1 bit 3 (enable operation)
Caution: When "master control from PC" is activated, this binector input is ineffective.
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
Note: Bit 3 = 0: Inhibit operation (cancel pulses)
Bit 3 = 1: Enable operation (pulses can be enabled)
Description: Sets the signal source for control word 1 bit 10 (master control by PLC).
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
Note: Bit 10 = 0: No master control by PLC
Bit 10 = 1: Master control by PLC
This bit is used to initiate a response for the drives when the control fails (F07220). If there is no control available,
then BI: p0854 should be set to a 1 signal.
If a control is available, control word 1 bit 10 = 1 (STW1.10, PZD1) must be set so that the received data is updated.
This applies regardless of the setting in p0854 and even in the case of free telegram configuration (p0922 = 999).
p0852[0...n] BI: Operation enable / Operation enable
CU230P-2 CAN
CU230P-2 HVAC
Access level: 3 Calculated: - Data type: U32 / Binary
Can be changed: T Scaling: - Data set: CDS, p0170
Min Max Factory setting
- - 1
p0852[0...n] BI: Operation enable / Operation enable
CU230P-2 DP Access level: 3 Calculated: - Data type: U32 / Binary
Can be changed: T Scaling: - Data set: CDS, p0170
Min Max Factory setting
- - 2090.3
p0854[0...n] BI: Master ctrl by PLC / Master ctrl by PLC
CU230P-2 CAN
CU230P-2 HVAC
Access level: 3 Calculated: - Data type: U32 / Binary
Can be changed: T Scaling: - Data set: CDS, p0170
Min Max Factory setting
- - 1