List of Parameters
Parameters
1-291
© Siemens AG 2009 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 11/2009
Description: Displays the status word for the "Hibernation" function.
Dependency: Refer to: p2398
Refer to: A07325
Description: Sets a fixed percentage.
Dependency: Refer to: p2901, p2930
Notice: A BICO interconnection to a parameter that belongs to a drive data set always acts on the effective data set.
Note: The value can be used to interconnect a scaling function (e.g. scaling of the main setpoint)
Description: Sets a fixed percentage.
Dependency: Refer to: p2900, p2930
Notice: A BICO interconnection to a parameter that belongs to a drive data set always acts on the effective data set.
Note: The value can be used to interconnect a scaling function (e.g. scaling of the supplementary setpoint)
r2399.0...8 CO/BO: Hibernation status word / Hib ZSW
Access level: 3 Calculated: - Data type: Unsigned32
Unit: - Scaling: - Data set: -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Hibernation enabled (p2398 <> 0) Yes No -
01 Hibernation active Yes No -
02 Hibernation delay time active Yes No -
03 Hibernation boost active Yes No -
04 Hibernation motor powered down Yes No -
05 Hibernation motor powered down cyclic
restart active
Yes No -
06 Hibernation motor restarts Yes No -
07 Hibernation supplies total setpoint for ramp-
function generator
Yes No -
08 Hibernation bypasses ramp-fct generator in
setpoint channel
Yes No -
p2900[0...n] CO: Fixed value 1 [%] / Fixed value 1 [%]
Access level: 3 Calculated: - Data type: FloatingPoint32
Can be changed: U, T Scaling: PERCENT Data set: DDS, p0180
Min Max Factory setting
-10000.00 [%] 10000.00 [%] 0.00 [%]
p2901[0...n] CO: Fixed value 2 [%] / Fixed value 2 [%]
Access level: 3 Calculated: - Data type: FloatingPoint32
Can be changed: U, T Scaling: PERCENT Data set: DDS, p0180
Min Max Factory setting
-10000.00 [%] 10000.00 [%] 0.00 [%]
To Next Page
Loading...
