Fig. 2-43 2503 – Status word, sequence control
- 2503 -
Function diagram
87654321
FP_2503_97_01.vsd
Internal control/status words
G120 CU230P-2
29.10.2009 V4.3
Status word, sequence control
11
12
13
14
15
PROFIdrive-Bit
10
9
8
7
6
5
4
3
0
1
2
r0899.0
r0899.1
r0899.4
r0899.5
r0899.11
r0899.2
r0899.6
r0899.9
r0899.3
r0899.7
r0899.8
1
&
(1)
2. OFF2
p0845 [C]
(1)
2. OFF3
p0849 [C]
OFF1
OFF2
OFF3
Enable internal
missing or
fault with
this reaction
From the control unit
From the control unit
From the control unit
From the control unit
From the control unit
From the control unit
From the control unit
From the control unit
Bit 9 = 1 --> Ready to exchange process data
From the control unit
The drive is ready to accept data.
Status word sequence control (r0899)
1 = Ready to power-up
1 = Ready to operate (DC link loaded, pulses blocked)
1 = Operation enabled (drive follows n_set)
1 = Jog active
1 = No coast down active (OFF2 inactive)
1 = No fast stop active (OFF3 inactive)
1 = Power-on inhibit active
1 = Drive ready
1 = Controller enable
1 = Control requested
Reserved
1 = Pulses enabled
Reserved
Reserved
ZSW seq_ctrl
r0899
r0899
Bit No.
<1>
Reserved
Reserved
<1>
To Next Page
Loading...
Need help?
General
