Siemens CU230P-2 DP User Manual

Parameters
List of Parameters
1-360
© Siemens AG 2009 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 11/2009
Description: Display parameter for the output quantity Y = X0 + X1 + X2 + X3 of instance ADD 0 of the adder.
Description: Setting parameter for the run-time group in which the instance ADD 0 of the adder is to be called.
Value: 5: Run-time group 5
6: Run-time group 6
9999: Do not calculate
Description: Setting parameter for the run sequence of instance ADD 0 within the run-time group set in p20096.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
Description: Sets the signal source of input quantities X0, X1, X2, X3 of instance ADD 1 of the adder.
Index: [0] = Input X0
[1] = Input X1
[2] = Input X2
[3] = Input X3
Description: Display parameter for the output quantity Y = X0 + X1 + X2 + X3 of instance ADD 1 of the adder.
Description: Setting parameter for the run-time group in which the instance ADD 1 of the adder is to be called.
Value: 5: Run-time group 5
6: Run-time group 6
9999: Do not calculate
r20095 CO: ADD 0 output Y / ADD 0 output Y
Access level: 3 Calculated: - Data type: FloatingPoint32
Unit: - Scaling: PERCENT Data set: -
p20096 ADD 0 run-time group / ADD 0 RTG
Access level: 3 Calculated: - Data type: Integer16
Can be changed: T Scaling: - Data set: -
Min Max Factory setting
5 9999 9999
p20097 ADD 0 run sequence / ADD 0 RunSeq
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: T Scaling: - Data set: -
Min Max Factory setting
0 32000 210
p20098[0...3] CI: ADD 1 inputs / ADD 1 inputs
Access level: 3 Calculated: - Data type: U32 / FloatingPoint32
Can be changed: T Scaling: PERCENT Data set: -
Min Max Factory setting
- - 0
r20099 CO: ADD 1 output Y / ADD 1 output Y
Access level: 3 Calculated: - Data type: FloatingPoint32
Unit: - Scaling: PERCENT Data set: -
p20100 ADD 1 run-time group / ADD 1 RTG
Access level: 3 Calculated: - Data type: Integer16
Can be changed: T Scaling: - Data set: -
Min Max Factory setting
5 9999 9999

Siemens CU230P-2 DP Specifications

General

Brand	Siemens
Model	CU230P-2 DP
Category	Control Unit
Language	English