List of Parameters
Parameters
1-235
© Siemens AG 2009 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 11/2009
Description: Connector output to interconnect PZD (setpoints) with word format received from the fieldbus master.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
Description: Selects the PZD (actual values) with word format to be sent to the fieldbus master.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
Description: Selects the PZD (actual values) with word format to be sent to the fieldbus master.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
r2050[0...7] CO: PROFIBUS PZD receive word / PZD recv word
Access level: 3 Calculated: - Data type: Integer16
Unit: - Scaling: 4000H Data set: -
p2051[0...7] CI: PROFIdrive PZD send word / PZD send word
CU230P-2 CAN
CU230P-2 HVAC
Access level: 3 Calculated: - Data type: U32 / Integer16
Can be changed: U, T Scaling: 4000H Data set: -
Min Max Factory setting
- - 0
p2051[0...7] CI: PROFIdrive PZD send word / PZD send word
CU230P-2 DP Access level: 3 Calculated: - Data type: U32 / Integer16
Can be changed: U, T Scaling: 4000H Data set: -
Min Max Factory setting
- - 2089[0]