Siemens CU230P-2 DP - r9975[0...7] System utilization measured; Sys util meas; r9976[0...7] System utilization; Sys util; r9999[0...99] Software error internal supplementary diagnostics; SW_err int diag

List of Parameters
Parameters
1-335
© Siemens AG 2009 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 11/2009
Description: Displays the measured system utilization. The higher the value displayed, the higher the system utilization.
Index: [0] = Computing time utilization (min)
[1] = Computing time utilization (averaged)
[2] = Computing time utilization (max)
[3] = Largest total utilization (min)
[4] = Largest total utilization (averaged)
[5] = Largest total utilization (max)
[6] = Reserved
[7] = Reserved
Dependency: Refer to: r9976
Refer to: F01205
Note: Re index 3 ... 5: The total utilizations are determined using all sampling times used. The largest total utilizations are
mapped here. The sampling time with the largest total utilization is displayed in r9979. Total utilization: Computing
time load of sampling time involved including load from higher-priority sampling times (interrupts).
Description: Displays the system utilization. If the utilization is greater than 100%, fault F01054 is output.
Index: [0] = Reserved
[1] = Computing time utilization
[2] = Reserved
[3] = Reserved
[4] = Reserved
[5] = Largest total utilization
[6] = Reserved
[7] = Reserved
Dependency: Refer to: F01205
Note: Re index 1:
The value shows the total computing time load of the system.
Re index 5:
The total utilization is determined using all sampling times used. The largest total utilization is mapped here. The
sampling time with the largest total utilization is displayed in r9979.
Total utilization:
Computing time load of sampling time involved including load from higher-priority sampling times (interrupts).
Description: Diagnostics parameter to display additional information for internal software errors.
Note: Only for internal Siemens troubleshooting.
r9975[0...7] System utilization measured / Sys util meas
Access level: 4 Calculated: - Data type: FloatingPoint32
Unit: [%] Scaling: - Data set: -
r9976[0...7] System utilization / Sys util
Access level: 3 Calculated: - Data type: FloatingPoint32
Unit: [%] Scaling: - Data set: -
r9999[0...99] Software error internal supplementary diagnostics / SW_err int diag
Access level: 4 Calculated: - Data type: Unsigned32
Unit: - Scaling: - Data set: -