Siemens CU230P-2 DP - p20362 MFP 3 run-time group; MFP 3 RTG; p20363 MFP 3 run sequence; MFP 3 RunSeq; p20372 CI: PLI 0 input X; PLI 0 input X; r20373 CO: PLI 0 output Y; PLI 0 output Y

List of Parameters
Parameters
1-401
© Siemens AG 2009 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 11/2009
Description: Setting parameter for the run-time group in which the instance MFP 3 of the pulse generator is to be called.
Value: 5: Run-time group 5
6: Run-time group 6
9999: Do not calculate
Description: Setting parameter for the run sequence of instance MFP 3 within the run-time group set in p20362.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
Description: Sets the signal source for input X of the polyline (20 breakpoints) of instance PLI 0.
Description: Display parameter for the output quantity Y of the polyline (20 breakpoints) of instance PLI 0
p20362 MFP 3 run-time group / MFP 3 RTG
Access level: 3 Calculated: - Data type: Integer16
Can be changed: T Scaling: - Data set: -
Min Max Factory setting
5 9999 9999
p20363 MFP 3 run sequence / MFP 3 RunSeq
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: T Scaling: - Data set: -
Min Max Factory setting
0 32000 960
p20372 CI: PLI 0 input X / PLI 0 input X
Access level: 3 Calculated: - Data type: U32 / FloatingPoint32
Can be changed: T Scaling: PERCENT Data set: -
Min Max Factory setting
- - 0
r20373 CO: PLI 0 output Y / PLI 0 output Y
Access level: 3 Calculated: - Data type: FloatingPoint32
Unit: - Scaling: PERCENT Data set: -