SMC Networks LECSB2-T Series - Page 555

16 - 55
16. POSITIONING MODE
(3) Changing the status display screen
The status display item of the driver display shown at power-on can be changed by changing [Pr. PC36]
settings. The item displayed in the initial status changes with the control mode as follows.
Control mode
Status display
Position
Cumulative feedback pulses
Position/speed
Cumulative feedback pulses/servo motor speed
Speed
Servo motor speed
Speed/torque
Servo motor speed/analog torque command voltage
Torque
Analog torque command voltage
Torque/position
Analog torque command voltage/cumulative feedback
pulses
Positioning (point table method/program
method)
Current position
Positioning (indexer method)
Cumulative feedback pulses