If setting values need to be changed with a high frequency (i.e. once or more per
one hour), write the setting values to the RAM, not to the EEP-ROM. The EEP-
ROM has a limitation in the number of write times and exceeding this limitation
causes the driver to malfunction. Note that the number of write times to the EEP-
ROM is limited to approximately 100,000.
(a) Position data
Writes position data of point tables.
Transmits the command [C] [0] + the data No. [0] [1] to [F] [F] corresponding to the point tables to
write + data. Refer to section 10.1.1.
Refer to the following
diagram.
When the position data is changed frequently using communication, set "1" to the mode to change
only the RAM data in the driver.
When changing data once or more within an hour, do not write it to the EEP-ROM.
Data is transferred in hexadecimal.
Writing mode
0: Writing to EEP-ROM/RAM
1: Writing to RAM
Decimal point position
0: No decimal point
1: First least significant digit (not used normally)
2: Second least significant digit
3: Third least significant digit
4: Forth least significant digit
5: Fifth least significant digit
6: Sixth least significant digit
Select the same decimal point position as
the set feed length multiplication (STM) in
[Pr. PT03].
If a different decimal point position is set,
slave stations will not receive data.
To Next Page
Loading...
Need help?
General