SMC Networks LECSB2-T Series - Page 844

16 - 344
16. POSITIONING MODE
(b) Speed data
Writes speed data of point tables.
Transmits the command [C] [6] + the data No. [0] [1] to [F] [F] corresponding to the point tables to
write + data. Refer to section 10.1.1.
Command
Data No.
Data
[C] [6]
[0] [1] to [F] [F]
Refer to the following
diagram.
When the speed data is changed frequently using communication, set "1" to the mode to change
only the RAM data in the driver.
When changing data once or more within an hour, do not write it to the EEP-ROM.
(c) Acceleration time constant
Writes acceleration time constant of point tables.
Transmits the command [C] [7] + the data No. [0] [1] to [F] [F] corresponding to the point tables to
write + data. Refer to section 10.1.1.
Command
Data No.
Data
[C] [7]
[0] [1] to [F] [F]
Refer to the following
diagram.
When the acceleration time constant is changed frequently using communication, set "1" to the
mode to change only the RAM data in the driver.
When changing data once or more within an hour, do not write it to the EEP-ROM.
Hexadecimal
Writing mode
0: Writing to EEP-ROM/RAM
1: Writing to RAM
0
Hexadecimal
Writing mode
0: Writing to EEP-ROM/RAM
1: Writing to RAM
0