SMC Networks LECSB2-T Series - Page 845

16 - 345
16. POSITIONING MODE
(d) Deceleration time constant
Writes deceleration time constant of point tables.
Transmits the command [C] [8] + the data No. [0] [1] to [F] [F] corresponding to the point tables to
write + data. Refer to section 10.1.1.
Command
Data No.
Data
[C] [8]
[0] [1] to [F] [F]
Refer to the following
diagram.
When the deceleration time constant is changed frequently using communication, set "1" to the
mode to change only the RAM data in the driver.
When changing data once or more within an hour, do not write it to the EEP-ROM.
(e) Dwell
Writes dwell of point tables.
Transmits the command [C] [A] + the data No. [0] [1] to [F] [F] corresponding to the point tables to
write + data. Refer to section 10.1.1.
Command
Data No.
Data
[C] [A]
[0] [1] to [F] [F]
Refer to the following
diagram.
When the dwell is changed frequently using communication, set "1" to the mode to change only the
RAM data in the driver.
When changing data once or more within an hour, do not write it to the EEP-ROM.
Hexadecimal
Writing mode
0: Writing to EEP-ROM/RAM
1: Writing to RAM
0
Hexadecimal
Writing mode
0: Writing to EEP-ROM/RAM
1: Writing to RAM
0