APPENDIX
App. - 27
*1. Parameter is set to the recommended value. Please set parameter according to customer application.
*2. Mechanical resonance may occur depending on the shape or mounting orientation of the work piece.
Please change this parameter during initial configuration.
(Parameter initial configuration ⇒ Set the recommended parameter value ⇒ Operation start)
*3. Other than positioning mode: Actuator travel distance at 10 [μm/pulse] per pulse.
Positioning Mode: Minimum actuator travel distance of 1[μm].
Recommended Value of acceleration time constant of Point table No.1
[LEF]
*4. Use the acceleration time constant of Point table No.1 as the acceleration time constant (msec)
of Home position return. Set the recommended value in the above figure.
To Next Page
Loading...