Revision history RM0033
1364/1381 RM0033 Rev 9
05-Nov-2012
5
(continued)
TIM1 to TIM8 (continued):
Updated configuration for example of counter operation in encoder
interface mode in Section 13.3.16: Encoder interface mode.
Updated Section 13.3.18: Interfacing with Hall sensors.
Changed definition of ARR[15:0] bits in Section 13.4.12: TIM1 and
TIM8 auto-reload register (TIMx_ARR).
Updated BKE definition in Section 13.4.18: TIM1 and TIM8 break
and dead-time register (TIMx_BDTR).
TIM2 to TM5:
Restored TIM2 to TIM5 block diagram.
Updated 16-bit prescaler range in Section 14.2: TIM2 to TIM5 main
features.
External clock mode 2 restricted to TIM2 to TIM4 in Section 14.3.3:
Clock selection.
Updated Section 14.3.6: PWM input mode and Section 14.3.11:
Clearing the OCxREF signal on an external event.
Updated Figure 153: Master/Slave timer example to change ITR1 to
ITR0. Updated Section : Starting 2 timers synchronously in response
to an external trigger. Restored bits 15 to 8 of TIMx_SMCR in
Section 14.4.3. Restored TIMx internal trigger connection table for
TIM2 to TIM5. Updated TIMx_CCER bit description for TIM2 to TIM5.
TIM6 to TIM7:
Updated 16-bit prescaler factor in Section 16.2: TIM6 and TIM7 main
features. Removed references to repetition counter.
HASH:
Updated Section 21.4.7: HASH context swap registers
(HASH_CSRx)
RNG:
Updated Section 20.1: RNG introduction.
RTC:
Updated Section : RTC register write protection.
Updated Section 22.3.8: RTC reference clock detection.
Added system reset value for Section 22.6.4: RTC initialization and
status register (RTC_ISR).
Added system reset value in Section 22.6.1: RTC time register
(RTC_TR), Section 22.6.2: RTC date register (RTC_DR). Changed
reset value to system reset value in Section 22.6.3: RTC control
register (RTC_CR). Added power-on reset value and changed reset
value to system reset value in Section 22.6.11: RTC time stamp time
register (RTC_TSTR). Updated definition of ALARMOUTTYPE in
Section 22.6.13: RTC tamper and alternate function configuration
register (RTC_TAFCR). Renamed RTC_BKxR into RTC_BKPxR in
Table 80: RTC register map and reset values.
Table 224. Document revision history (continued)
Date Version Changes
To Next Page
Loading...
Need help?
General
