A. Chapter Configuration
The first page of each chapter shows the number of the chapter and the title. The second page
shows the contents. Where applicable, each chapter contains the topics that follow:
- System Description and Operation
- Trouble-Shooting
- Maintenance Procedures. Where applicable, the maintenance procedures give information
on these procedures:
Removal
Installation
Check
Adjustment
Removal procedures contain the minimum steps to remove a component.
Installation procedures can include steps to install parts that might not have been
removed. If a component is already correctly installed, then the steps can be skipped
during installation.
B. Page Numbering System
This manual uses the ATA Spec 100 page block-numbering system. The page number is at the
bottom of the page at the outer edge. It is adjacent to the chapter number.
Each topic in a section has numbers from these page blocks:
- Description and Operation - Pages 1 to 99.
- Trouble-Shooting - Pages 101 to 199.
- Maintenance Procedures - Pages 201 to 299.
C. Figures
Figures are given numbers in sequence. The first figure in a chapter is Figure 1.
To Next Page
Loading...
