Austro Engine E4 Series - Install the Oil Filter

E4 Series
Maintenance Manual
Engine Oil
System
E4.08.04
Rev. 29
Page 207
79-Maintenance Procedures
01-Jul-2020
Detail Steps/Work Items
Key Items/References
Refer to Section 79-30-00 Paragraph
3.B
(8)
Install the fitting on the housing drain line
with a new sealing ring.
Torque 18 Nm.
Refer to Fig. 79 - 6.
(9)
Install the oil filter housing drain line.
Refer to Section 79-20-00 Paragraph
4.B
(10)
Install the oil filter.
Refer to Section 79-20-00 Paragraph
3.B
(11)
Connect the oil pressure sensor to the engine
harness.
(12)
Clean the working area.
(13)
Do an engine ground run.
Refer to Section 71-00-01.
(14)
Examine the oil system for leakage.
Fig. 79 - 5 O-Rings on the oil filter housing
O-Rings