Austro Engine E4 Series - Transport and Packaging; General; Packaging

E4 Series
Maintenance Manual
Transport and
Packaging
E4.08.04
Rev.29
Page 1
02 – Transport and Packaging
01-Jul-2020
02-00-00 Transport and Packaging
1. General
This chapter contains information about packaging and transport of the engine attached to the
corresponding mountings.
2. Packaging
Detail Steps/Work Items
Key Items/References
(1)
Put the engine in a wooden box.
If not specified differently, ship the
engine without any liquids.
(2)
Fill the box that contains the supplied parts
with filler material.
Refer to Fig. 02 - 1.
(3)
Close the box with adhesive tape.
(4)
Attach an envelope with the engine
documents on the box.
Refer to Fig. 02 - 2.
(5)
Put the box in position in the slope below the
injector cover.
Refer to Fig. 02 - 3.
(6)
Use a special VCI foil (anti corrosion) as a
cover for the engine.
Refer to Fig. 02 - 4.
(7)
Close the engine in a wooden box.
Refer to Fig. 02 - 5 and Fig. 02 - 6.
Fig. 02 - 1