Austro Engine E4 Series - Oil Separator Return Line; Remove the Oil Separator Return Line; Install the Oil Separator Return Line

E4 Series
Maintenance Manual
Engine Oil
System
Page 218
E4.08.04
Rev. 29
79-Maintenance Procedures
01-Jul-2020
Fig. 79 - 13 Oil separator installation
7. Oil Separator Return Line
A. Remove the Oil Separator Return Line
Detail Steps/Work Items
Key Items/References
(1)
Remove the lock-wire from the banjo bolt on the
camshaft sensor housing.
Refer to Fig. 79 - 15.
(2)
Remove the banjo bolt at the camshaft sensor
housing.
Refer to Fig. 79 - 14 and Fig. 79 -
15.
(3)
Remove the screw that attaches the oil line to
the injector cover.
(4)
Remove the oil line.
Refer to Fig. 79 - 14.
B. Install the Oil Separator Return Line
Detail Steps/Work Items
Key Items/References
(1)
Use a new O-Ring at the screw that attaches the
oil line to the injector cover. Lubricate it with
engine oil.
Refer to Fig. 79 - 14.
Injector cover
Injector cover
screws
Oil pipe
Hose 2