Austro Engine E4 Series - (D) Results of the Timing Chain Check

E4 Series
Maintenance Manual
Reciprocating
Engine
Page 318
E4.08.04
Rev. 29
85-Maintenance Procedures
01-Jul-2020
Fig. 85 - 140 Belt pulley with TDC („OT“) indicator
(d) Results of the timing chain check
 If during the check sequence, in one of the check steps you see one or less of the red
indicator ring on the TCMT scale, replace the timing chain and the camshaft chain wheel.
Continue with Paragraph B.
 If during the check sequence, you see always more than one red indicator ring on the
TCMT scale, continue with Paragraph (e).
TDC Indicator
Pointer