Austro Engine E4 Series - Intake Air Temperature Sensor (IAT); Remove the IAT Sensor; Install the IAT Sensor

E4 Series
Maintenance Manual
Reciprocating
Engine
E4.08.04
Rev. 29
Page 273
85-Maintenance Procedures
01-Jul-2020
3. Intake Air Temperature Sensor (IAT)
A. Remove the IAT sensor
Detail Steps/Work Items
Key Items/References
(1)
Disconnect the electrical connectors IAT1 and
IAT2.
Refer to Fig. 85 - 90.
(2)
Remove the IAT sensors.
B. Install the IAT sensor
Detail Steps/Work Items
Key Items/References
(1)
Install the IAT sensor with a new sealing ring.
Refer to Fig. 85 - 90.
(2)
Tighten the IAT sensor.
Torque 5 Nm.
Refer to Fig. 85 - 90.
(3)
Connect the electrical connector IAT1 or
IAT2.
(4)
Do an engine ground run.
Refer to Section 71-00-01.