Austro Engine E4 Series User Manual

E4 Series
Maintenance Manual
Reciprocating
Engine
E4.08.04
Rev. 29
Page 229
85-Maintenance Procedures
01-Jul-2020
C. Examine the Hub
Detail Steps/Work Items
Key Items/References
(1)
Before you remove the hub, make sure there
is no clearance between the flange of the
secondary mass of the flywheel and the
flange of the hub.
No clearance is permitted between
the two flanges.
If you see a clearance, replace the
two-mass flywheel and the hub.
Refer to Fig. 85 - 45 for clearance
between flanges after an incorrect
installation.
(2)
Visually examine the hub for:
- Cracks
- Other mechanical damages (e.g.
dents, deformations)
If you find any damage, replace the
hub. Engrave the new hub on the
surface facing away from the flywheel
with the serial number of the
flywheel. Refer to Fig. 85 - 46.
Obey the scheduled maintenance
intervals. Refer to Section 05-20-00.
Fig. 85 - 45 Clearance between the hub of the flange and the flange of the
secondary mass
Clearance

Austro Engine E4 Series Specifications

General

Brand	Austro Engine
Model	E4 Series
Category	Engine
Language	English