Austro Engine E4 Series - Mark the Two-Mass Flywheel after Inspection

E4 Series
Maintenance Manual
Reciprocating
Engine
Page 252
E4.08.04
Rev. 29
85-Maintenance Procedures
01-Jul-2020
G. Mark the Two-Mass Flywheel after inspection
Detail Steps/Work Items
Key Items/References
Do not hit the part to prevent damage to the two-mass flywheel.
(1)
If you do not find any damage during the
visual and mechanical inspection, identify the
two-mass flywheel with a mark:
- Make a mark with a “x” on the
flywheel next to the part number.
Refer to Fig. 85 - 72.
Make a “x” mark every time you
complete this maintenance
procedure of the two-mass flywheel.
Fig. 85 - 72 Two-Mass Flywheel inspection mark
„x“ mark