Time Limits and
Maintenance
Check
05-20-00 Scheduled Maintenance Checks
This section describes the scheduled maintenance checks for the E4 Series.
The scheduled annual inspection consists of the 100 hours inspection program.
Activities/Service Interval
Send the following data to Austro Engine GmbH:
– Serial Number of the Engine(s)
ï€ Serial Number of the Aircraft
ï€ Aircraft Registration Marks
ï€ Company
Review the applicable Airworthiness Directives.
Review the applicable Service Bulletins.
Review the Life-Limited Parts list. Refer to Section 05-10-00.
Review the Component Maintenance Requirements.
Visually examine the whole engine surface using a flashlight and a
mirror.
– Look especially for signs of wear and leakage at the oil sump
gasket and the cylinder head gasket.
ï€ Examine for loose parts or foreign objects.
Examine the glow plug control. Refer to Section 80-00-00.
Examine the Alternator according to Chapter 24-00-00.
Visually examine the wiring harness for signs of wear or damage.
ï€ Make sure that the camshaft sensor connection and the
injector connections are tight fitted.
Visually examine the wiring harness that is not covered by the injector
cover for signs of wear or damage.
Make sure that the sensor connections are fitted tight.
CAUTION: To prevent any damage on cables and sensor, do not put
too much force on cables!
Read out EECU using the AE 300 Wizard.
Send the following data to Austro Engine GmbH:
– Engine log
ï€ Event recorder
ï€ Engine data log
Examine the fault code memory of the EECU for failure.
Refer to Section 76-10-00.
Visually examine the Gearbox.
Look for leakages at the housing and propeller shaft.
Measure the Gearbox Oil level according to Section 12-10-00.