EasyManua.ls Logo

Austro Engine E4 Series - Page 72

Default Icon
658 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
E4 Series
Maintenance Manual
Time Limits and
Maintenance
Check
Page 202
E4.08.04
Rev. 29
05-Maintenance Check
20-Jul-2020
Activities/Service Interval
100 h
300 h
14.
Drain the Gearbox Oil according to Section 85-10-00.
X
X
15.
Examine the Gearbox Oil according to Section 85-10-00.
X
X
16.
Collect a sample of used Gearbox Oil using the oil container provided
with the 300 h Service Kit.
Send the oil sample to oil check directly (pre-filled out
envelope).
X
17.
Examine the Gearbox Oil Filter according to Section 85-10-00.
X
X
18.
Replace the Gearbox Oil Filter according to Section 85-10-00.
X
19.
Refill the Gearbox Oil according to Section 85-10-00.
X
X
BELT DRIVE SYSTEM
20.
Visually examine the V-Ribbed Belt.
Look especially for abrasion and signs of damage:
Textile reinforcement visible between the ribs
Tapered ribs
Transverse cracks on the running surface
Dirt between the ribs
Transverse cracks in the ribs
Frayed textile reinforcement.
In case of dirt clean the V-Ribbed Belt using water only.
X
X
21.
Examine the belt pulley profiles and the tensioner for damage and dirt.
X
X
ENGINE OIL
22.
Drain the Engine Oil according to Section 79-20-00 Paragraph 5.A.
X
X
23.
Collect a sample of the used Engine Oil using the oil container provided
with the 100 h Service Kit.
Send the oil sample to oil check directly (pre-filled out
envelope).
X
X
24.
Replace the Engine Oil Filter according to Section 79-20-00 Paragraph
3.
X
X
25.
Visually examine the used Oil Filter for contamination and metal
abrasion.
If an abnormal condition is found (metal shavings exceeding
1.5 mm; concentration of particles; clogged filter), this
condition must be corrected (e.g. by exchange of defective
component within published repair procedures) before further
operation of the engine.
X
X
26.
Fill the Engine Oil according to Section 79-20-00 Paragraph 5.B.
X
X
FUEL SYSTEM
27.
Visually examine the Fuel System for signs of wear and leakage.
Make sure that the fittings are tightened.
X
X
28.
Replace the Fuel Filter in accordance with the applicable Aircraft
Maintenance Manual.
X
X

Table of Contents

Other manuals for Austro Engine E4 Series

Related product manuals