Austro Engine E4 Series - Remove the Glow Plugs; Install the Glow Plugs

E4 Series
Maintenance Manual
Starting
E4.08.04
Rev. 29
Page 205
80 - Maintenance Procedures
01-Jul-2020
B. Remove the Glow Plugs
Detail Steps/Work Items
Key Items/References
(1)
Carefully remove the cable connectors
(GP1/GP2/GP3/GP4) from the cylinder head.
Refer to Fig. 80 - 6.
(2)
Remove the glow plugs.
C. Install the Glow Plugs
Detail Steps/Work Items
Key Items/References
(1)
Tighten the glow plugs.
Torque 11 Nm.
Refer to Fig. 80 - 5.
(2)
Attach the cable connectors with a clip.
Refer to Fig. 80 - 6.
(3)
Do an engine ground run.
Refer to Section 71-00-01.
Fig. 80 - 5 Glow Plugs installation
Glow plugs