Austro Engine E4 Series - Page 560

E4 Series
Maintenance Manual
Reciprocating
Engine
Page 272
E4.08.04
Rev. 29
85-Maintenance Procedures
01-Jul-2020
If new sensors (AEP-00286-901) are installed, do the following steps:
Detail Steps/Work Items
Key Items/References
(1)
Tighten the Boost Pressure Sensor [04a] with
a new sealing ring [04b] on the spacer [04c].
Torque 15 Nm.
Refer to Fig. 85 - 91.
(2)
Connect the electrical connectors BPS1 and
BPS2.
(3)
Do an engine ground run.
Refer to Section 71-00-01.