Austro Engine E4 Series - Page 189

E4 Series
Maintenance Manual
Power Plant
E4.08.04
Rev. 29
Page 203
71 -Maintenance Procedures
01-Jul-2020
For any maintenance procedure on the camshaft sensor, complete the following
procedure before the Engine Ground Test Run:
Switch ECU-Voter
to ECU_A
Crank the engine
Engine start‘s
No
Yes
Turn off engine
Switch ECU-Voter
to ECU_B
Crank the engine
Engine start‘s
Test OK
Check ECU_B sensor
Target wheel and/or
System
Check engine
mechanical /
electrical System
No
Yes