Austro Engine E4 Series - Page 254

E4 Series
Maintenance Manual
Power Plant
Page 268
E4.08.04
Rev. 29
71 - Maintenance Procedures
01-Jul-2020
Detail Steps/Work Items
Key Items/References
(1)
Connect the CAS2 branch to sensor.
Refer to Fig. 71 - 87 and Fig. 71 - 88.
(2)
Connect the pigtail of CAS2 to the blade
terminal installed with CAS1.
(3)
Connect the pigtail of CAS1 to the pigtail of
CAS2 (double connector).
Refer to Fig. 71 - 89.
(4)
Install the BPA blade terminal [11] with the
BPA mounting screw.
Torque 3 Nm.
Apply Loctite 243.
Refer to Fig. 71 - 90.
(5)
Connect the pigtail of the BPA to the blade
terminal of the BPA.
Refer to Fig. 71 - 91.
(6)
Attach the branch of BPA and CAS2 to the
BPA housing.
Use the edge clip No.[06] and cable tie
No.[05]
Refer to Fig. 71 - 92.
Only the cable tie is permitted for connector adapter (of BPA filter)
attachment.
Do not tighten the BPA hose with too much force!
(8)
Attach the BPA filter.
Use a cable tie No.[05]