Austro Engine E4 Series - Page 564

E4 Series
Maintenance Manual
Reciprocating
Engine
Page 276
E4.08.04
Rev. 29
85-Maintenance Procedures
01-Jul-2020
Parts that are used again for the cylinder head installation:
 Camshaft position sensors CAS 1 and CAS 2
 Camshaft sensor housing for CAS 2, only if old camshafts are used
 Exhaust manifold
 Turbocharger, if not specified differently in the Scheduled Maintenance Table
Section 05-20-00
 Injector cover
 Oil separator
 Lubricant line
 Oil return line
 EGR closing covers
 Camshafts (not applicable for engine model E4P)
 Timing chain
 Chain tensioner
 Fastening bolt for timing chain guide
 High pressure pump, if not specified differently in the Scheduled Maintenance
Table Chapter 05-30-00.
 Injectors, if not specified differently in the Scheduled Maintenance Table
 Glow plugs
 Common rail and lines
 Intake manifold
 Wiring harness
 All screws (not applicable for cylinder head screws and expansion bolts of the
injectors).