Austro Engine E4 Series User Manual

E4 Series
Maintenance Manual
Reciprocating
Engine
Page 344
E4.08.04
Rev. 29
85-Maintenance Procedures
01-Jul-2020
4. Coolant Thermostat
A. Remove the coolant thermostat
Detail Steps/Work Items
Key Items/References
(1)
Drain the coolant.
Refer to the applicable Aircraft
Maintenance Manual.
(2)
Remove the coolant hoses attached to the
coolant thermostat.
(3)
Remove the two screws from the coolant
thermostat.
Refer to Fig. 85 - 163.
(4)
Remove the coolant thermostat.
B. Install the coolant thermostat
Detail Steps/Work Items
Key Items/References
(1)
Install a new O-Ring.
(2)
Install the coolant hoses to the coolant
thermostat.
Refer to the applicable Aircraft
Maintenance Manual.
(3)
Clean the connecting surface of the intake air
manifold, if necessary.
(4)
Lubricate the O-Ring with engine oil.
Use a new O-Ring.
(5)
Install the coolant thermostat with the O-Ring
onto the intake air manifold.
Make sure the coolant thermostat and
the O-Ring are correctly installed.
Make sure the thermostat applies no
tension on the air intake manifold.
Refer to Fig. 85 - 163 and Fig. 85 -
164.
(6)
Tighten the two screws with the clamp of the
wiring harness on the coolant thermostat.
Torque 12 Nm.
If engine harness E4A-95-000-000, or
E4B-95-000-000is used, it is not
necessary to install the clamp of the
wiring harness.
(7)
Fill and bleed the coolant system.
Refer to the applicable Aircraft
Maintenance Manual.
(8)
Clean the working area.
(9)
Do an engine ground run.
Refer to Section 71-00-01.
(10)
Examine the coolant system for leakage.

Austro Engine E4 Series Specifications

General

Brand	Austro Engine
Model	E4 Series
Category	Engine
Language	English